Design and engineering guidelines

 The design and the engineering of an incineration plant requires a few decisive parameters. The type and amount of waste has to be known and the type of technology is then selected.

Layout of an incineration plant

The layout of an incineration plant is a general drawing of all the necessary buildings and aditional equipment. There is a building for the waste incinerator, there is a building for administration, a building for waste storage, a balance, etc.  Everything must comply with to the aplicabe and very strict law.
Learn more...

Engineering guidelines and materials

Our plant are designed according to EU laws, norms and codes of practice using the metric system of units. Plant supplied outside the EU are of course be adapted where necessary to comply with local codes of practice. But the most important aspect in engineering of a waste incinerator is the technical creativity.
Learn more...

Emission measurements and instrumentation

Emissions are politically the most important problem of a waste incinerator, this is why the emission regulations are changing fast in economically growing countries. The EU emission regulations are the most strict in the world. This is why it is adviced to design the plant according to the EU regulation, if the law changes, your installation will not be easlily out-dated.
Learn more...

Software and control systems

To operate the plant safely, the software or control system automatically  takes care for all interllocks. It is for example not possible to heat up the installation in 3 hours, thermal expansion and friction of different type of materials of the incinerator would damage the plant. The control system takes care that everything has the correct temperature before heating from for ex. 465 degr. C to 600 degr. C.
Learn more...